Using the global automatic settings with a minimum gap size of 0.1 in. The geometry I introduced in the first blog shown below contains narrow passageways, drilled holes and a small bump feature on the top angled surface. As stated previously, the goal is to create an accurate mesh without an excessive cell count that will allow an efficient and accurate solution. Here, I dive into some of the manual settings, which offer multiple ways to influence the size and arrangement of cells. The focus there was on the global automatic settings. ![]() This blog continues the quest to understand the computational fluid dynamics (CFD) mesh settings in SOLIDWORKS Flow Simulation that I initiated in my first blog.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |